On page 18 of the weemote® X Reference Guide covering the options for setting the Channel Changing settings, an option step was omitted from the manual. This step is to clear any of the channel changing options you may have previously set.
Please find below a corrected update to this section of the manual.
1. Press and hold down the “C” button for about 3 seconds until the LED light turns on solid green. Then, release the button.
2. Press and release the “A” button. The LED light will blink and turn on solid green.
A. To insert the enter signal, press and release the favorite #1 button.
B. To insert the select signal, press and release the favorite #2 button.
C. To insert one leading zero, press and release the favorite #3 button. For example, channel 7 will be sent as 007.
D. To insert two leading zeros, press and release the favorite #4 button. For example, channel 7 will be sent as 0007.
E. To clear any of the settings you may have made above, press and release the favorite #5 button.
Whichever option is set above, the LED light will blink three times green to confirm it has been set.